Our CHI Overhead Doors torsion spring replacement service in Aurora, CO comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Torsion springs replaced and wound correctly, with high-cycle upgrades available. We work on CHI Overhead Doors garage doors of every age, from older models to current lines, and carry or can source compatible parts. CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.
Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.
When to call for CHI Overhead Doors torsion spring replacement
- A gap in the spring mounted on the bar above the door
- The door slams shut or won't stay open
- Only one side of the door lifts and the door goes crooked
- The door is suddenly too heavy to lift by hand
What usually causes it
- Normal fatigue at the end of the spring's rated cycles
- Rust or lack of lubrication
- An undersized spring working too hard
- A door that's been made heavier with insulation or new panels
What you can check yourself
- Count the springs above the door. Two-spring doors should have both replaced together.
- Look for rust or dry, squeaky coils, which are signs the spring is wearing out.
- Note how often the door is used each day so the right cycle rating can be chosen.
Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.
What happens during the visit
- Clamp the door and unwind the old springs with proper winding bars
- Measure wire size, inside diameter and length, and weigh the door
- Install correctly rated springs, upgrading to high-cycle if you use the door a lot
- Wind to the right number of turns and set the door's balance
- Lubricate, adjust the cables and test the full travel
Wayne Dalton TorqueMaster doors keep the springs inside the torsion tube and need TorqueMaster-specific parts, which we can source.
How much does CHI Overhead Doors torsion spring replacement cost?
What moves the price:
- Door size and weight (single or double, steel or wood)
- Which parts need replacing and whether they are in stock
- Spring type and cycle rating
- Emergency or after-hours timing
These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.
Other CHI Overhead Doors services
- CHI Overhead Doors Garage Door Repair
- CHI Overhead Doors Extension Spring Replacement
- CHI Overhead Doors Garage Door Cable Repair
- CHI Overhead Doors Garage Door Roller Replacement
- CHI Overhead Doors Garage Door Track Repair
- CHI Overhead Doors Off-Track Garage Door Repair
- CHI Overhead Doors Garage Door Panel Replacement
- CHI Overhead Doors Weather Seal Replacement
- CHI Overhead Doors Garage Door Installation
- CHI Overhead Doors Commercial Garage Door Repair
- CHI Overhead Doors Rolling Steel Door Repair
Local CHI Overhead Doors torsion spring replacement for Aurora, CO
In Colorado, cold mornings after mild afternoons put the most stress on worn springs, so breaks are common in late fall and winter.
Technicians serve all of Aurora (ZIP codes 80010, 80011, 80012, 80013, 80014 and more), plus Glendale (5.7 mi), Commerce City (7.7 mi), Denver (8.1 mi) and Cherry Creek (8.3 mi). Call (833) 435-8883 to book a visit in Aurora.
CHI Overhead Doors Torsion Spring Replacement: frequently asked questions
How much does CHI Overhead Doors torsion spring replacement cost in Aurora, CO?
CHI Overhead Doors Torsion Spring Replacement typically costs $200-$450 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.
Can you do CHI Overhead Doors torsion spring replacement the same day?
Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.
Is CHI Overhead Doors torsion spring replacement covered by a warranty?
Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and CHI Overhead Doors warranty terms vary by product and age. Ask for the warranty details in writing with your quote.
Are your technicians licensed and insured?
Our technicians are insured, and where Colorado or Aurora requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.
Should I repair or replace my garage door?
A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.